HPRT PPD3, User Manual

Page: 11 / 30

PPD3 User Manual
8
CHAPTER 3 OPERATION METHODS
3.1 Connecting the Power Cord
Note: Before connecting/disconnecting the power cord, make sure that power to the printer and all the
devices connected to the printer is turned off. Also make sure the power cable plug is disconnected from the AC
outlet.
(1) Check the label on the back or bottom of the printer to make sure its voltage matches that of the AC outlet.
Also make sure the plug on the power cord matches the AC outlet.
(2) If the power cord is not attached to the printer, plug the appropriate end into the AC inlet on the back of the
printer.
(3) Plug the power cord into a properly grounded AC outlet
Warnings:

If the voltage shown on the label on the of your printer does not match the voltage for your area,
contact your dealer immediately.

The power cord is designed for use with this printer only. Do not connect it to any other device.

Please only use the power adapter are recommended by supplied or equivalent products;

When disconnecting the AC adapter plug, handheld plug connector housing, to avoid the pulling on the
cable in force;

Avoid drag the power adapter cable, otherwise it will damage the cables, causing fire and shock;

Avoid put power adapter around a heating device, otherwise the cable may melt, causing fire and shock;

If you do not use the printer in a long time, disconnect the power supply of printer power adapter .
Note:

The plug of power adapter is designed in a switch type, when accessing power adapter and uttered the
voice "click", it means the connected socket switch is locked the adapter connect well, otherwise please
connect again .

When pull out the adapter, please pinch the shell of power adapter and pull the switch up, when the
switch is fully opened then pull out the power adapter. Don’t put forth your strength to pull the plug by
squeeze at any of place of power adapter .Because, it is more difficult to pull it out and easy to damage the
cable.