• Operating range up to 70m (D641/PIFL
and D641/PILR)
• 2 melodies for selection
• Weather resistant bell press
• Flashing Light (D641/PIFL only)
• Visitor alert
• Panic button
• Pager
1
2
Features
Typical Applications
8 Troubleshooting
9 Maintenance
PROBLEM
SUGGESTED SOLUTION
The Door Chime is intermittent
when activated or sounds when
not activated at all.
A door chime with the same frequency may be nearby. Change the
channel on your HPM Door Chime (Refer Channel Selection section).
The Door Chime has stopped
sounding.
Your Bell Press Unit battery may be flat. If the red indicator light
on the Bell Press Unit no longer illuminates when the Bell Press is
pressed, replace the Bell Press battery. (Refer Installation section -
Bell Press Unit).
If you have checked your Bell
Press battery and your Door
Chime is still not sounding.
Check the distance between the Chime Unit and the Bell Press Unit.
Relocate closer, if they are too far away from each other. Relocate
further away, if they are within 1m of each other.
Check the position of your Chime Unit and Bell Press. Relocate if
they are close to a metal structure as it may be interfering with the
transmission.
Ensure Bell Press Unit and Chime Unit have the same Channel
selected. (Refer Channel Selection section).
The Volume Control may be in the OFF position. Move the Volume
Control to either LOW or HIGH (D641/PIFL only).
Warranty
HPM Legrand warrants this product for a period of 3 years
from the date of purchase.
These goods come with guarantees that cannot be
excluded under the Australian and New Zealand Consumer
Laws. You are entitled to a replacement or a refund
for a major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired if the goods fail to be
of acceptable quality and the failure does not amount to a
major failure.
See the Warranty card enclosed with this product for
further details.
Customer Service
For all Customer Service and Technical Support
please call Monday to Friday during business hours.
LE07950AAA
Specifications
Bell press supply voltage: 12V d.c
Transmission freq:
433.92MHz
Range:
Up to 35m (D641/PI)
Up to 70m (D641/PIFL and D641/PILR)
Sound level:
70 dB
Battery requirement:
Door chime receiver:
Mains Power
Bell press transmitter:
1 x 12V A23 battery (supplied)
This series of wireless door chimes are not compatible
with units from HPM’s Cat D642 and D641 series or with
D641/B, D641/BLR or D641/BLRCC.
Box contents
• Bell Press
• Door Chime receiver
• 1 x 12V battery
• Mounting screws and wall plugs
• Double-sided tape
HPM Legrand Australia
1300 369 777
www.hpm.com.au
HPM Legrand New Zealand
0800 476 009
www.hpm.co.nz
ABN: 31 000 102 661
Keep the Chime Unit dry. Liquids can damage the electronic circuits inside. To clean, use a damp
cloth and mild detergent. Do not use solvents. Do not leave exhausted batteries in the Bell Press Unit
or the Chime Unit. Keep the Chime Unit away from dust and dirt, which can prematurely wear parts.
Modifying or tampering your HPM Door Chime’s internal components can cause a malfunction and will
invalidate its Warranty.
Wireless Door Chime
Plug-in
Cat. D641/PI, D641/PILR, D641/PIFL
Instruction Manual
Please read all instructions carefully before installation and use.
