4.
Slide the access panel towards the rear of the compute module, and then lift to remove the panel.
To replace the component:
1.
Place the access panel on top of the compute module.
2.
Slide the access panel rearward until it clicks into place.
Removing and replacing a drive blank
Remove the component as indicated.
CAUTION:
To prevent improper cooling and thermal damage, do not operate the compute module unless all bays
are populated with either a component or a blank.
To replace the blank, slide the blank into the bay until it locks into place.
Removing and replacing a drive blank
33
Summary of Contents for Synergy 480 Gen10 series
Page 23: ...Customer self repair 23 ...
Page 24: ...24 Customer self repair ...
Page 25: ...Customer self repair 25 ...
Page 26: ...26 Customer self repair ...
