Field
Description
Manage Client Permissions
If the backup application supports this, you can remotely manage
which Client IDs exist in the system and which Client IDs are able to
access which stores. Only enable this if the backup software
supports this feature. Refer to your client application's
documentation for further details.
NOTE:
A Client ID must be defined from the GUI and then enabled
for this feature before a backup application using that Client ID can
connect to the StoreOnce appliance and further manipulate data for
other Client IDs.
WARNING:
When enabled, this feature allows anyone with
access to the backup application the ability to change the
Client ID settings, thereby giving users on one system control
over and full access to all backup targets.
Apply to All Service Sets
When enabled (default), any client changes made are applied to all
service sets within the cluster.
Editing a client
Prerequisites
Only an administrator can edit StoreOnce Catalyst clients.
Procedure
1.
Navigate to the
StoreOnce
>
StoreOnce Catalyst
>
Clients
tab.
2.
Select the client to edit.
3.
Click
Edit
.
4.
Change the client information as needed. See
for details.
5.
Click
Update
.
Deleting a client
Prerequisites
Only an administrator can delete StoreOnce Catalyst clients.
Procedure
1.
Navigate to the
StoreOnce
>
StoreOnce Catalyst
>
Clients
tab.
2.
Select the client to delete.
“Apply to all Service Sets” is enabled by default; this deletes the client across all service sets. Deselect
this check box to delete the client from only the service set selected at the top of the page. Hewlett
Packard Enterprise recommends using “Apply to all Service Sets” to maintain configuration
consistency. This is especially important when using StoreOnce Federated Catalyst.
84
Editing a client
