Removing and replacing the M.2 enablement backplane
IMPORTANT:
The left and right sides of the chassis are oriented 180° from each other. Components
that are installed on one side of the chassis must be turned 180° when they are installed on the opposite
side.
Procedure
1.
Power down the server (
on page 28).
2.
Remove the server (
on page 28).
3.
Place the server on a flat, level work surface.
4.
Remove the access panel (
on page 29).
5.
on page 29).
6.
Disconnect the cable from the M.2 enablement backplane.
7.
Remove the M.2 enablement backplane.
To replace the component, reverse the removal procedure.
Removing and replacing the M.2 SSD drive
IMPORTANT:
The left and right sides of the chassis are oriented 180° from each other. Components
that are installed on one side of the chassis must be turned 180° when they are installed on the opposite
side.
Procedure
1.
Power down the server (
on page 28).
2.
Remove the server (
on page 28).
3.
Place the server on a flat, level work surface.
4.
Remove the access panel (
on page 29).
34
Removal and replacement procedures
Summary of Contents for ProLiant XL230k Gen10
