To replace the component, reverse the removal procedure.
Removing the rear support bracket
IMPORTANT:
The left and right sides of the chassis are oriented 180° from each other. Components
that are installed on one side of the chassis must be turned 180° when they are installed on the opposite
side.
Procedure
1.
Power down the server (
on page 28).
2.
Remove the server (
on page 28).
3.
Place the server on a flat, level work surface.
4.
Remove the access panel (
on page 29).
5.
Remove the rear support bracket.
Removal and replacement procedures
31
Summary of Contents for ProLiant XL230k Gen10
