The installation is complete.
Installing an expansion board in the secondary riser cage
The server supports multiple riser options in the secondary position. For more information on the
secondary riser options, see
Secondary riser board components
on page 16.
CAUTION:
The maximum inlet ambient temperature for most components installed in the system is
35°C (95°F). Some components, however, are subject to thermal limitations depending on the
chassis model and the fan configuration. There are some hardware configurations where it is
necessary to limit the number of drives installed in the chassis. For more information, see
.
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1.
2.
Disconnect all peripheral cables from the server.
3.
Remove the server from the chassis
on page 19.
4.
on page 21.
5.
.
6.
Remove the secondary riser cage
on page 27.
7.
Remove the secondary riser slot blank.
8.
If installed, remove the full-height bracket from the expansion board.
52
Hardware options installation
