Install the primary riser cage
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
1.
Install the primary riser cage. Make sure that the riser board is firmly seated in its system board the
connector.
2.
Do one of the following:
•
Install the secondary riser blank
•
Install the secondary riser cage
on page 28.
3.
4.
on page 22.
6. Install the server into the chassis
7.
Connect all peripheral cables to the server.
on page 19.
Remove the primary riser blank
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless
either riser blank or riser cage is installed.
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
30
Operations
