HPE ProLiant DL20 Gen10 Plus, User Manual, Page: 70 / 212

Installing the rack rail hook-and-loop strap Installing the rack rail hook-and-loop strap
Use the rack rail hook-and-loop strap to manage the rear panel cables. The hook-and-loop strap can be installed on either the left or
right rack mounting rail.
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-25 Torx screwdriver available.
Procedure Procedure
1. Attach the strap carabiner to the rack mounting rail.
2. Bundle the rear panel power cords and peripheral cables, and then wrap the strap around the cables.
3. Verify that the peripheral cables and power cords are secured properly.
Two people are needed for this procedure: one to slide the server in and out of the rack, and the other to observe the peripheral
cables and power cords.
a. Fully extend the server out of the rack.
b. Make sure that there is enough slack in the cables and cords secured in the hook-and-loop strap for a full extension of the rack
rails.
Make sure that there is no cable binding or crimping.
c. Slide the server in and out of the rack to verify that there is no risk of accidental disconnection of the peripheral cables and
power cords.
4. Secure the server on the rack, do one of the following:
For a server that has thumbscrew ears, tighten the captive thumbscrews.
Installing the rack rail hook-and-loop strap 70