30
Replacement procedure
Replacing a power supply
The power supplies are hot swappable.
To replace a power supply:
1.
Use a Phillips screwdriver to remove the captive screws on the power supply.
2.
Holding the power supply handle with one hand and supporting the bottom of the power supply
with the other, gently pull the power supply out from the slot.
3.
Put the removed power supply on a workbench or in an anti-static bag.
4.
Install a new power supply. For information about installing a power supply, see "Installing the
router."
If no power supply is installed, install a filler panel into the slot.
Figure 32 Removing a power supply
Replacing a SIC
1.
Completely loosen the captive screws of the SIC.
2.
Gently pull the SIC out along the slide rails.
3.
Install a new SIC. For the installation procedure, see "Installing the router."
If you do not install a SIC, install a filler panel and tighten the screws.
Figure 33 Removing the SIC
