75
route-option bypass-route
Use
route-option bypass-route
to enable the routing table bypass feature to test the connectivity to
the direct destination.
Use
undo
route-option bypass-route
to disable the routing table bypass feature.
Syntax
route-option bypass-route
undo route-option bypass-route
Default
The routing table bypass feature is disabled.
Views
DLSw/DNS/FTP/HTTP/SNMP/TCP/voice operation view
ICMP/UDP echo operation view
ICMP/UDP jitter operation view
UDP tracert operation view
Predefined user roles
network-admin
Usage guidelines
When the routing table bypass feature is enabled, the following events occur:
•
The routing table is not searched. Packets are sent to the destination in a directly connected
network.
•
The TTL value in the probe packet is set to 1. The TTL set in the
ttl
command does not take
effect.
Examples
# Enable the routing table bypass feature.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] route-option bypass-route
source interface
Use
source interface
to specify the IP address of the specified interface as the source IP address of
probe packets.
Use
undo
source interface
to restore the default.
