68
undo radius trap
{
accounting-server-down
|
authentication-error-threshold
|
authentication-server-down
}
Default
The trap function is disabled for RADIUS.
Views
System view
Default command level
2: System level
Parameters
accounting-server-down
: Sends traps when the reachability of the accounting server changes.
authentication-error-threshold
: Sends traps when the number of authentication failures exceed
the specified threshold. The threshold is represented by the ratio of the number of failed request
transmission attempts to the total number of transmission attempts. It ranges from 1 to 100 and
defaults to 30. This threshold can only be configured through the MIB.
authentication-server-down
: Sends traps when the reachability of the authentication server
changes.
Usage guidelines
With the trap function for RADIUS, a NAS sends a trap message in the following cases:
•
When the status of a RADIUS server changes. If a NAS sends a request but receives no
response before the maximum number of attempts is exceeded, it places the server to the
blocked state and sends a trap message. If a NAS receives a response from a RADIUS server
it considered unreachable, it considers that the RADIUS server is reachable again and also
sends a trap message.
•
When the ratio of the number of failed transmission attempts to the total number of
authentication request transmission attempts reaches the threshold.
Examples
# Enable the device to send traps in response to accounting server reachability changes.
<Sysname> system-view
[Sysname] radius trap accounting-server-down
reset radius statistics
Use
reset radius statistics
to clear RADIUS statistics.
Syntax
In standalone mode:
reset radius statistics
[
slot
slot-number
]
In IRF mode:
reset radius statistics
[
chassis
chassis-number
slot
slot-number
]
Views
User view
Default command level
2: System level
