HPE FlexNetwork 10500 SERIES, Configuration Manual

Page: 37 / 407

26
Step Command Remarks
5. Set the interval at which
the NQA operation
repeats.
frequency interval
For a voice or path jitter operation, the
default setting is 60000 milliseconds.
For other types of operations, the default
setting is 0 milliseconds, and only one
operation is performed.
If the operation is not completed when the
interval expires, the next operation does
not start.
6. Specify the probe times.
probe count times
By default:
•
In an UDP tracert operation, the
NQA client performs three probes to
each hop to the destination.
•
In other types of operations, the
NQA client performs one probe to
the destination per operation.
This command is not available for the
path jitter and voice operations. Each of
these operations performs only one
probe.
7. Set the probe timeout
time.
probe timeout timeout
The default setting is 3000 milliseconds.
This command is not available for the
ICMP jitter, path jitter, UDP jitter, or voice
operations.
8. Set the maximum
number of hops that the
probe packets can
traverse.
ttl value
The default setting is 30 for probe packets
of the UDP tracert operation, and is 20 for
probe packets of other types of
operations.
This command is not available for the
DHCP or path jitter operation.
9. Set the ToS value in the
IP header of probe
packets.
tos value The default setting is 0.
10. Enable the routing table
bypass feature.
route-option bypass-route
By default, the routing table bypass
feature is disabled.
This command is not available for the
DHCP and path jitter operations.
11. Specify the VPN instance
where the operation is
performed.
vpn-instance
vpn-instance-name
By default, the operation is performed on
the public network.
Configuring the collaboration feature
Collaboration is implemented by associating a reaction entry of an NQA operation with a track entry.
The reaction entry monitors the NQA operation. If the number of operation failures reaches the
specified threshold, the configured action is triggered.
To configure the collaboration feature:
Step Command Remarks
1. Enter system view.
system-view N/A