HPE FlexNetwork 10500 SERIES, Configuration Manual, Page: 36 / 407

25
Step Command Remarks
5. (Optional.) Set the payload size
for each ICMP echo request.
data-size size The default setting is 100 bytes.
6. (Optional.) Specify the payload
fill string for ICMP echo
requests.
data-fill string
The default payload fill string is the
hexhexadecimal string
00010203040506070809.
7. Specify the source IP address
of ICMP echo requests.
source ip ip-address
By default, the packets take the
primary IP address of the output
interface as their source IP address.
The source IP address must be the
IP address of a local interface, and
the interface must be up. Otherwise,
no ICMP echo requests can be sent
out.
8. (Optional.) Set the number of
ICMP echo requests to be sent
in a path jitter operation.
probe packet-number
packet-number
The default setting is 10.
9. (Optional.) Set the interval for
sending ICMP echo requests.
probe packet-interval
interval
The default setting is 20
milliseconds.
10. (Optional.) Specify how long
the NQA client waits for a
response from the server
before it regards the response
times out.
probe packet-timeout
timeout
The default setting is 3000
milliseconds.
11. (Optional.) Specify an LSR
path.
lsr-path ip-address &<1-8>
By default, no LSR path is specified.
The path jitter operation uses the
tracert to detect the LSR path to the
destination, and sends ICMP echo
requests to each hop on the LSR.
12. (Optional.) Perform the path
jitter operation only on the
destination address.
target-only
By default, the path jitter operation is
performed on each hop on the path
to the destination.
Configuring optional parameters for the NQA operation
Unless otherwise specified, the following optional parameters apply to all types of NQA operations.
The parameter settings take effect only on the current operation.
To configure optional parameters for an NQA operation:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Create an NQA operation
and enter NQA operation
view.
nqa entry admin-name
operation-tag
By default, no NQA operations exist.
3. Specify an NQA
operation type and enter
its view.
type
{
dhcp
|
dlsw
|
dns
|
ftp
|
http | icmp-echo | icmp-jitter
|
path-jitter
|
snmp
|
tcp |
udp-echo | udp-jitter |
udp-tracert
|
voice
}
N/A
4. Configure a description.
description text
By default, no description is configured.