HPE FlexNetwork 10500 SERIES, Configuration Manual

Page: 303 / 407

292
Task Command Remarks
Change the directory of the
security log file.
a system-view
b info-center
security-logfile directory
dir-name
By default, the security log file is
saved in the
seclog directory in the
root directory of the storage device.
(In standalone mode.) This
command cannot survive a reboot
or an active/standby switchover.
(In IRF mode.) This command
cannot survive an IRF reboot or a
global active/standby switchover in
an IRF fabric.
Manually save all the contents in
the security log file buffer to the
security log file.
security-logfile save Available in any view.
Saving diagnostic logs to the diagnostic log file
By default, the device saves diagnostic logs from the diagnostic log file buffer to the diagnostic log
file every 24 hours. You can adjust the saving interval or manually save diagnostic logs to the
diagnostic log file. After saving diagnostic logs to the diagnostic log file, the system clears the
diagnostic log file buffer.
The device supports multiple diagnostic log files. Each diagnostic log file has a maximum capacity.
The diagnostic log files are named as
diagfile1.log , diagfile2.log , and so on. When diagfile1.log is
full, the system compresses diagfile1.log as diagfile1.log.gz and creates a new diagnostic log file
named diagfile2.log . The process repeats until the last diagnostic log file is full.
After the last diagnostic log file is full, the device repeats the following process:
1. The device locates the oldest compressed diagnostic log file diagfileX.log.gz and creates a
new file using the same name ( diagfileX.log ).
2. When diagfileX.log is full, the device compresses the log file as diagfileX.log.gz to replace the
existing file diagfileX.log.gz .
To avoid loss of important logs, back up the diagnostic log files regularly.
To enable saving diagnostic logs to the diagnostic log file:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enable the information
center.
info-center enable
By default, the information center
is enabled.
3. Enable saving diagnostic
logs to the diagnostic log file.
info-center diagnostic-logfile
enable
By default, saving diagnostic logs
to the diagnostic log file is
enabled.
4. (Optional.) Set the maximum
size for the diagnostic log
file.
info-center diagnostic-logfile
quota size
The default setting is 10 MB.
To ensure normal operation, set
the
size argument to a value
between 1 MB and 10 MB.