C-28
Compaq StorageWorks SSL2000 Series Library Maintenance and Service Guide
5.
Remove the screws on both sides of the bottom pulley assembly (
Figure C-29).
cc0048
1
Figure C-29. Releasing the bottom pulley assembly
6.
Slide the bottom pulley assembly
out of the PTM extrusion (see Figure C-30).
cc0049
1
2
Figure C-30. Removing the bottom pulley assembly
Setting up Interfaces and Cables
The following sections describe the cables required for each of the connectors at the rear panel
(see Figure C-31).
See section “Cabling the PTM and Multi-Unit Library System” for detailed information on how
to connect cables to the PTM motor housing assembly and Library units.
