Ports A1-A2
auto
Filter multicast traffic. Forward
IGMP traffic to hosts on these ports
that belong to the multicast group
for which the traffic is intended.
(Also forward any multicast traffic
through any of these ports that is
connected to a multicast router.)
Ports A3-A4
forward
Forward all multicast traffic through
this port.
Ports A5-A6
blocked
Drop all multicast traffic received
from devices on these ports.
For a description of the default behavior of data-driven switches, see
Depending on the privilege level, you could use one of the following commands to configure IGMP on VLAN 1
with the above settings:
switch(config)# vlan 1 ip igmp auto a1,a2 forward a3,a4
blocked a5,a6
switch(vlan-1)# ip igmp auto a1,a2 forward a3,a4
blocked a5,a6
The following command displays the VLAN and per-port configuration resulting from the above commands.
switch show ip igmp vlan 1 config
vlan ip igmp querier
Syntax:
[no] vlan
vid
ip igmp querier
This command disables or re-enables the ability for the switch to become querier if necessary.
The
no
version of the command disables the querier function on the switch. The
show ip igmp config
command displays the current querier command.
Default querier capability: Enabled
ip igmp querier interval
To specify the number of seconds between membership queries, enter this command with the desired interval.
Syntax:
[no] ip igmp querier interval [5-300]
NOTE:
This command must be issued in a VLAN context.
Specifies the number of seconds between membership queries. The no form of the command sets the interval to
the default of 125 seconds.
Default: 125 seconds
24
Aruba 3810 / 5400R Multicast and Routing Guide for ArubaOS-
Switch 16.08
