This guide provides information on how to configure IGMP, PIM and routing protocols.
Applicable products
This guide applies to these products:
Aruba 3810 Switch Series (JL071A, JL072A, JL073A, JL074A, JL075A, JL076A)
Aruba 5400R zl2 Switch Series (J9821A, J9822A, J9850A, J9851A, JL001A, JL002A, JL003A, JL095A)
Switch prompts used in this guide
Examples in this guide are representative and may not match your particular switch/environment. Examples use
simplified prompts as follows:
Prompt
Explanation
switch#
#
indicates manager context (authority).
switch>
>
indicates operator context (authority).
switch(config)#
(config)
indicates the config context.
switch(vlan-
x
)#
(vlan-
x
)
indicates the vlan context of config, where
x
represents the VLAN ID. For example:
switch(vlan-128)#
.
switch(eth-
x
)#
(eth-
x
)
indicates the interface context of config,
where
x
represents the interface. For example:
switch(eth-48)#
.
switch-Stack#
Stack
indicates that stacking is enabled.
switch-Stack(config)#
Stack(config)
indicates the config context while
stacking is enabled.
switch-Stack(stacking)#
Stack(stacking)
indicates the stacking context of
config while stacking is enabled.
switch-Stack(vlan-
x
)#
Stack(vlan-
x
)
indicates the vlan context of config
while stacking is enabled, where
x
represents the
VLAN ID. For example:
switch-
Stack(vlan-128)#
.
switch-Stack(eth-
x
/
y
)#
Stack(eth-
x
/
y
)
indicates the interface context of
config, in the form
(eth-
<member-in-stack>
/
<interface>
)
. For example:
switch(eth-1/48)#
Chapter 1
About this guide
18
Aruba 3810 / 5400R Multicast and Routing Guide for ArubaOS-
Switch 16.08
