Configuring an IPv6 Route
Syntax:
[no] ipv6 route
dest-ip-addr / prefix-length
[
next-hop-gateway-addr
| vlan vid |
tunnel tunnel-id|blackhole|reject] [metric metric] [distance1-255] [tag-value
tagval] [name <string>]
dest-ipv6-addr / prefix-length
The network prefix for the destination IPv6 address.
next-hop-gateway-addr|vlan <vid> | tunnel <tunnel-id>>
The gateway for reaching the destination. The next-hop address option (link-local or global unicast) is not
required to be directly reachable on a local subnet. (If it is not directly reachable, the route will be added to the
routing table when a path to this address is learned.) If the next-hop address is link-local, it must include both
the address and the applicable VLAN VID or tunnel <tunnel-id>. For example:
FE80::127%vlan10
, where
VLAN 10 is the interface where
FE80::127
exists. For a tunnel, it would be
FE80::127%tun3.
blackhole
Specifies a null route where IP traffic for the specified destination is discarded and no ICMP error notification
is returned to the sender.
reject
Specifies a null route where IP traffic for the specified destination is discarded and an ICMP error notification
is returned to the sender.
metric
Specifies an integer value that is associated with the route. It is used to compare a static route to routes in the
IP route table from other sources to the same destination.
distance
Specifies the administrative distance to associate with a static route. If not specified, this value is set to a
default of 1. (Range: 1 to 255)
tag
Specifies a unique integer value for a given ECMP set (destination, metric, distance.)
name <name-str>
Assigns a name to a static route.
The
no
form of the command deletes the specified static or null route from the routing table.
158
Aruba 3810 / 5400R Multicast and Routing Guide for ArubaOS-
Switch 16.08
