HPE AH395-9013J, User'S & Service Manual

Page: 148 / 204

To replace the component, see Installing a hot-swappable power supply on page 58.
Removing and replacing the access panel
To remove the access panel see Removing the access panel .
To replace the component, reverse the removal procedure.
Removing and replacing the optical drive filler
To remove the component:
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all bays are
populated with either a component or a blank.
Procedure
1. Power off the server ( Powering off the server ).
2. Extend or remove the server from the rack.
3. Remove the access panel. See Removing the access panel .
4. Remove the fans 2 and 3. See Removing and replacing a hot-swap fan on page 150.
5. Push out the drive filler.
NOTE:
You might have to use a nonconductive tool with a length of at least 20 cm and a thickness of
about 1 mm to push out the drive filler. Hewlett Packard Enterprise recommends using a ruler or
similar tool.
To replace the component, reverse the removal procedure.
Removing and replacing the optical drive
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all bays are
populated with either a component or a blank.
Procedure
1. Power off the server ( Powering off the server ).
2. Extend or remove the server from the rack. See Removing the server from the rack .
3. Remove the access panel. See Removing the access panel .
4. Remove the fans 2 and 3. See Removing and replacing a hot-swap fan .
5. Disconnect the drive cable.
148 Removing and replacing the access panel