Figure 48: 40G QSFP+ to 4 x 10G SFP+ network cable
(1) QSFP+ module
(2) QSFP+ side pull latch
(3) SFP+ side pull latch
(4) SFP+ module
For more information about the QSFP+ transceiver module and QSFP+ network cables, see HPE Comware-Based Devices
Transceiver Modules User Guide.
NOTE:
• As a best practice, use QSFP+ transceiver modules or QSFP+ network cables for the QSFP+ ports on the switch. The HPE
QSFP+ transceiver modules and QSFP+ network cables are subject to change over time. For the most up-to-date list of
HPE QSFP+ transceiver modules and QSFP+ network cables, contact your Hewlett Packard Enterprise sales representative
or technical support engineer.
• You can use an HPE X140 40G QSFP+ MPO SR4 transceiver (JG325B) or HPE X140 40G QSFP+ MPO MM 850nm CSR4
300m transceiver (JG709A) to connect a QSFP+ port to four SFP+ ports. The QSFP+ transceiver module and SFP+
transceiver modules to be connected must be the same in specifications, including central wavelength and fiber type.
10/100/1000Base-T autosensing Ethernet port
The HPE 5900AF-48G-4XG-2QSFP+ and HPE 5900AF-48G-4XG-2QSFP+ TAA switches have 10/100/1000Base-T
autosensing Ethernet ports.
Table 13: 10/100/1000Base-T autosensing Ethernet port specifications
Item
Specification
Connector type
RJ-45
Port transmission rate
10/100/1000 Mbps, half/full duplex, MDI/MDI-X autosensing
Table Continued
66 Ports and LEDs
