318
Step Command
Remarks
multicast-address-specific
queries.
source-ip
{
ipv6-address
|
current-interface
}
default.
Configuring MLD snooping proxying
This section describes how to configure MLD snooping proxying.
Configuration prerequisites
Before you configure MLD snooping proxying in a VLAN, complete the following tasks:
•
Enable MLD snooping in the VLAN.
•
Determine the source IPv6 address for the MLD reports sent by the proxy.
•
Determine the source IPv6 address for the MLD done messages sent by the proxy.
Enabling MLD snooping proxying
The MLD snooping proxying function works on a per-VLAN basis. After you enable the function in a
VLAN, the device works as the MLD snooping proxy for the downstream hosts and upstream router
in the VLAN.
To enable MLD snooping proxying in a VLAN:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter VLAN view.
vlan
vlan-id
N/A
3.
Enable MLD snooping
proxying in the VLAN.
mld-snooping proxying enable
Disabled by default.
Configuring the source IPv6 addresses for the MLD
messages sent by the proxy
You can set the source IPv6 addresses of the MLD reports and done messages that the MLD
snooping proxy sends on behalf of its attached hosts.
To configure the source IPv6 addresses of MLD messages that the MLD snooping proxy sends in a
VLAN:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter VLAN view.
vlan
vlan-id
N/A
3.
Configure the source IPv6
address of MLD reports that
the proxy sends.
mld-snooping report source-ip
{
ipv6-address
|
current-interface
}
The default is
FE80::02FF:FFFF:FE00:0001.
4.
Configure the source IPv6
address of MLD done
messages that the proxy
sends.
mld-snooping done source-ip
{
ipv6-address
|
current-interface
}
The default is
FE80::02FF:FFFF:FE00:0001.
