235
Table 8 Description of the both, send, and receive parameters and the negotiation result
Local parameter
Peer parameter
Negotiation result
send
•
receive
•
both
The ORF sending capability is enabled locally and
the ORF receiving capability is enabled on the
peer.
receive
•
send
•
both
The ORF receiving capability is enabled locally
and the ORF sending capability is enabled on the
peer.
both both
Both the ORF sending and receiving capabilities
are enabled locally and on the peer.
Configuring the maximum number of MBGP ECMP routes
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter BGP view.
bgp
as-number
N/A
3.
Enter IPv4 MBGP address
family view.
ipv4-family multicast
N/A
4.
Set the maximum number of
MBGP ECMP routes.
balance
[
ebgp
|
ibgp
]
number
By default, load balancing is not
configured.
Configuring a large scale MBGP network
Refer to the following information for details about configuring a large scale MBGP network.
Configuration prerequisites
Before you configure this task, you must make peering nodes accessible to each other at the
network layer.
Configuring IPv4 MBGP peer groups
In a large-scale network, configuration and maintenance become difficult due to large numbers of
MBGP peers. You can configure peer groups to make management easier and improve route
distribution efficiency.
To configure an MBGP peer group, you must enable the corresponding IPv4 BGP unicast peer group
in IPv4 MBGP address family view.
Before adding an MBGP peer to an MBGP peer group, you must add the corresponding IPv4 unicast
peer to the IPv4 BGP peer group.
To configure an IPv4 MBGP peer group:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
