10.
Remove the system board (3) by sliding it up and to the right at an angle.
Reverse this procedure to install the system board.
Fan/heat sink assembly
Description
Spare part number
For use only on tablet models equipped with a graphics subsystem with discrete memory (includes two fan
cables and replacement thermal material)
L03256-001
For use only on tablet models equipped with a graphics subsystem with UMA memory (includes fan cable
and replacement thermal material)
L03257-001
Before removing the fan/heat sink assembly, follow these steps:
1.
Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2.
Disconnect all external devices connected to the tablet.
3.
Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the tablet.
4.
Remove the display panel assembly (see
Display panel assembly on page 30
), and then remove the
following components:
a.
Front-facing webcam/microphone module (see
Front-facing webcam/microphone module
)
b.
Battery (see
c.
System board (see
)
Remove the fan/heat sink assembly:
1.
Position the system board upside down with the rear edge toward you.
50
Chapter 5 Removal and replacement procedures
Summary of Contents for ZBook x2
Page 4: ...iv Safety warning notice ...
Page 8: ...viii ...