HP ZBook Fury 17 G7, Maintenance And Service Manual, Page: 76 / 232

2. Press down on the module until the side retention clips snap into place (3).
Solid-state drive 1
To remove solid-state drive 1, use this procedure and illustration.
Table 5-11 Solid-state drive description and part number
Description Spare part number
1 TB, M.2 2280, PCIe, NVMe-3×4, SS with TLC L85348-001
512 GB, M.2 2280, PCIe-3×4, SS with TLC L85360-001
512 GB, M.2 2280, PCIe, NVMe, SED with TLC L85368-002
256 GB, M.2 2280, PCIe-3×4, SS with TLC L85350-001
256 GB, M.2 2280, PCIe, NVMe, SED with TLC M07245-001
Before removing solid-state drive 1, follow these steps:
1. Prepare the computer for disassembly ( Preparation for disassembly on page 66 ).
2. Remove the service cover ( Service cover on page 40 ).
3. Remove the battery (see Battery on page 41 ).
4. Remove the keyboard (see Keyboard on page 54 ).
Remove solid-state drive 1:
1. Remove the Phillips M2.0 × 2.9 screw (1) that secures the solid-state drive 1 cover to the computer.
2. Lift the right side (2) of the cover until it rests at an angle.
62 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts ENWW