HP ZBook Fury 17 G7, Maintenance And Service Manual, Page: 57 / 232

Table 5-3 Solid-state drive description and part number (continued)
Description Spare part number
256 GB, M.2 2280, PCIe-3×4, SS with TLC L85350-001
256 GB, M.2 2280, PCIe, NVMe, SED with TLC M07245-001
Before removing solid-state drive 3 and 4, follow these steps:
1. Prepare the computer for disassembly ( Preparation for disassembly on page 66 ).
2. Remove the service cover ( Service cover on page 40 ).
3. Remove the battery (see Battery on page 41 ).
Remove solid-state drives 3 and 4:
1. Remove the slotted 1.9 × 8.9 screw (1) that secures the solid-state drive to the solid-state drive carrier.
2. Spread the retention tabs (2) that secure the solid-state drive carrier gate.
3. Swing the solid-state drive carrier gate (3) up and back.
4. Slide the solid-state drives away from the slots (4) on the system board.
Solid-state drives are designed with a notch (5) to prevent incorrect installation.
5. If it is necessary to remove the solid-state drive carrier, loosen the captive Phillips screw (1) that secures
the carrier to the computer.
6. Lift the front edge of the carrier (2) until it rests at an angle.
ENWW Component replacement procedures 43