Hinge components
Before disassembling the hinge assembly, follow these steps:
1.
Remove the bottom cover (see
2.
Remove the hinge assembly (see
Disassemble the hinge assembly:
1.
Peel the Mylar from the hinge assembly. A tool such as tweezers may be required to grasp the Mylar. The
Mylar is secured with adhesive and is reusable.
The Mylar is available in the hinge bezel kit using the following spare part numbers:
Silver HP x2 and HP x2 210 G2 models: 902377-001
White HP x2 models: 902378-001
Red HP x2 models: 902379-001
2.
To remove the hinge bezel, remove the two silver outer Phillips PM2.0×6.0 screws (1).
3.
Remove the black middle Phillips PM2.0×5.0 screw (2).
4.
Use a tool to pry in the gap near the docking connector to pry the bezel loose (3).
48
Chapter 5 Removal and replacement procedures
Summary of Contents for X2 210 G2
Page 4: ...iv Safety warning notice ...
Page 8: ...viii ...
