Parameter Tables
6-36
syslog host table
syslog host table
syslog host table
syslog host table
The table described below configures the Syslog hosts that will receive message from the WL520. You can configure up to ten
Syslog hosts. Note that you can only configure one Syslog host via the HTTP interface (row 1, which defaults to 10.0.0.2).
iapp parameters
iapp parameters
iapp parameters
iapp parameters
NOTE:
These parameters configure the Inter Access Point Protocol (IAPP) for roaming. Leave these settings at their default
value unless a technical representative asks you to change them.
spectralink voip parameters
spectralink voip parameters
spectralink voip parameters
spectralink voip parameters
name
name
name
name
type
type
type
type
values
values
values
values
access
access
access
access
cli parameter
cli parameter
cli parameter
cli parameter
Syslog Host Table
Table
N/A
R
sysloghosttbl
Table Index
Integer
1 – 10
N/A
index
IP Address
IpAddress
User Defined
RW
ipaddr
Comment (optional)
DisplayString
User Defined
RW
cmt
Status (optional)
Integer
enable
disable
delete
RW
status
name
name
name
name
type
type
type
type
values
values
values
values
access
access
access
access
cli parameter
cli parameter
cli parameter
cli parameter
IAPP
Group
N/A
R
iapp
IAPP Status
Integer
enable (default)
disable
RW
iappstatus
Periodic Announce Interval
(seconds)
Integer
80
120 (default)
160
200
RW
iappannint
Announce Response Time
Integer
2 seconds
R
iappannresp
Handover Time-out
Integer
410 ms
512 ms (default)
614 ms
717 ms
819 ms
RW
iapphandtout
Max. Handover
Retransmissions
Integer
1 - 10 (default 4)
RW
iapphandretx
Send Announce Request on
Startup
Integer
enable (default)
disable
RW
iappannreqstart
name
name
name
name
type
type
type
type
values
values
values
values
access
access
access
access
cli parameter
cli parameter
cli parameter
cli parameter
Spectralink VoIP
Group
N/A
R
spectralink
Spectralink VoIP Status
Integer
enable
disable (default)
RW
speclinkstatus
