HP VXI 75000 C Series, User'S And Scpi Programming Manual

Page: 50 / 438

50 Field Wiring Chapter 2
Terminal Module
Accessories
The following accessories are necessary for use with crimp-and-insert Option A3E:
Single-Conductor and Contact
A crimp-and-insert contact is crimped onto one end of a wire. The other end is not
terminated. Order HP 91510A.
Shielded-Twisted-Pair and Contacts
A crimp-and-insert contact is crimped onto each conductor at one end of a
shielded-twisted-pair cable. The other end is not terminated. Order HP 91511A.
Jumper Wire and Contacts
A crimp-and-insert contact is crimped onto each end of a single conductor jumper
wire. This jumper is typically used to tie two pins together in a single
crimp-and-insert connector. Order HP 91512A.
Crimp-and-Insert Contacts
These contacts may be crimped onto a conductor and then inserted into a
crimp-and-insert connector. The crimp tool kit is required to crimp the contacts onto
a conductor and remove the contact from the connector. Order HP 91515A.
L e n g t h : 2 m e t e r s
W i r e G a u g e : 2 4 A W G
Q u a n t i t y : 5 0 e a c h
I n s u la t io n R a t in g : 1 0 5 ° C m a x i m u m
V o l t a g e : 3 0 0 V
L e n g t h : 2 m e t e r s
W i r e G a u g e : 2 4 A W G
O u t s i d e D i a m e t e r : 0 . 1 i n c h e s
Q u a n t i t y : 2 5 e a c h
I n s u l a t i o n R a t i n g : 2 5 0 ° C m a x i m u
V o l t a g e : 6 0 0 V
Wire Gauge Range: 20 - 24 AWG
Quantity: 250 each
Plating: Gold Plated Contact
Maximum Current: 2A at 70°C