HP VMA Series, Installation And Service Manual

Page: 46 / 300

Chapter 3 - Installing the Array
46
VMA-series Memory Array Installation and Service Guide HP-AM456-9002A Rev 01
Connecting the PCIe Cable to the Memory Array
The Memory Array communicates with the host computer via the PCIe
(Peripheral Component Interconnect Express) connection. The PCIe cable must
be connected to the PCIe port with the flashing LED. The software image on the
system dictates which interface port is used. The image names are listed in the
table below.
Where
<release>
indicates the release number; for example, A3.7.2-18919.
Note:
Ensure that the:
• Bend radius of the PCIe cable is greater than 1.9".
• PCIe cable is connected to the port with the flashing LED.
To connect the PCIe cable to the Memory Array PCIe connector:
1.
Locate the appropriate PCIe connector port at the rear of the Memory
Array. This is indicated by the flashing LED that is associated with the port.
Figure 3.5 Connecting the PCIe Cable to the Memory Array
2.
Orient one connector of the PCIe cable so it aligns appropriately with the
PCIe connector at the rear of the Memory Array.
3.
Securely plug the cable into the PCIe connector port on the Memory Array.
4.
If using the cable management arm, route the PCIe cable according to the
instructions in
Routing the Cables onto the Cable Management Arm on
page 55.
Table 3.2 Image Names
Image Name PCIe Interface Interface ID
v3000_Series_x8_p1_df-
<release>
.upg PCIe x8 Interface for V3000 Port 1
v3000_Series_x4_p1p2_df-
<release>
.upg Dual PCIe x4 Interfaces for V3000 Ports 1 and 2
LOC
A RAID
ADMIN
AC OK DC OK STA
TUS
ALARM
B
PCIe
Port 1
PCIe
Port 2