HP Synergy 480 Gen9, Maintenance And Service Manual, Page: 45 / 71

Removing and replacing the drive backplane
To remove the component:
Procedure
1. Power down the compute module .
2. Remove the compute module .
3. Place the compute module on a flat, level work surface.
4. Remove the access panel .
5. Remove all drives .
6. Remove all drive blanks .
CAUTION:
Remove all drives and drive blanks before removing the drive backplane.
7. Remove all DIMM baffles .
8. Remove the front panel/drive cage assembly .
9. Remove the drive backplane from the front panel/drive cage assembly.
To replace the component, reverse the removal procedure.
Removing and replacing the internal SATA board
To remove the component:
Procedure
1. Power down the compute module .
2. Remove the compute module .
3. Place the compute module on a flat, level work surface.
4. Remove the access panel .
5. Remove all drives .
6. Remove all drive blanks .
CAUTION:
Remove all drives and drive blanks before removing the drive backplane.
Removing and replacing the drive backplane 45