Figure 14 StoreOnce 3500 Series rear view
1
2
3
4
1
5
6
4
4
1
iLO
PS2
PS1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Slot 2, SAS expander card
2
Slot 1, available for Optional Hardware
1
Slot 4, available for Optional Hardware
4
Slot 3, RAID controller card
3
Slot 6, available for Optional Hardware
6
Slot 5, available for Optional Hardware
5
Power supply 1 (PS1)
8
Optional serial port
7
Video connector
10
Power supply 2 (PS2)
9
1Gb RJ45 Port 3
12
1Gb RJ45 Port 4
11
1Gb RJ45 Port 1 (eth0)
14
1Gb RJ45 Port 2
13
USB connectors
16
iLO4 connector
15
Rear UID LED
17
StoreOnce 5100 System
Storage expansion
The StoreOnce 5100 System supports capacity expansion. Up to five Capacity Upgrade Kits
may be added to the base configuration. These are factory configured and will have a label in
the format: JBOD # for <server_warranty_number>. The Capacity Upgrade Kits must be connected
to the correct StoreOnce 5100 System in the recommended sequence. If they are not, the
StoreOnce 5100 System will not be able to discover the storage and make it available for use.
IMPORTANT:
Refer to the
HPE StoreOnce 5100 48TB Capacity Upgrade Kit Guide
for detailed
instructions about installing and configuring Capacity Upgrade Kits both at initial installation and
at a later date.
Optional hardware
The StoreOnce 5100 System provides four PCIe slots for the addition of StoreOnce 10 GbE or
10 GbE-T Network Cards or StoreOnce 8Gb Fibre Channel cards. These additional PCIe cards
may be pre-installed or supplied in separate boxes. Some cards also require SFP+ transceivers,
which will be supplied with the kit.
IMPORTANT:
Refer to the
StoreOnce 10 GbE Network Card and StoreOnce Fibre Channel
Card Installation and Configuration Guide
for detailed instructions about installing and cabling
optional PCIe cards and make sure the correct SFP+ transceivers are fitted, if required.
StoreOnce 5100 System
57