To disable library-managed encryption, set the encryption mode to
Controlled by Backup
Application
. When encryption is disabled for a partition, encrypted media in that partition cannot be
read until the same encryption method is enabled.
3.
Click
Submit
.
MSL Encryption Kit configuration
The
Configuration > Encryption > USB—MSL Encryption Kit
screen displays information about the
key server token and provides access to enter the key server token password and configure a new key
server token. Access to this screen is only available to the security user.
For additional information on using the encryption kit, see the
HPE StoreEver MSL Encryption Kit User
Guide
on the Hewlett Packard Enterprise Support website:
http://www.hpe.com/support/manuals
terms “token PIN” and “token password” are used interchangeably in the encryption kit documentation.
Entering the key server token password when using the MSL Encryption Kit
Procedure
1.
Navigate to the
Configuration > Encryption > USB—MSL Encryption Kit
screen.
2.
Verify that the correct key server token is available.
3.
Enter the
Token Password
and then click
Submit
.
Viewing the keys on the key server token when using the MSL Encryption Kit
Procedure
1.
Navigate to the
Configuration > Encryption > USB—MSL Encryption Kit
screen.
2.
If the
Keys on the Key Server Token
area is not visible, click
Gather Key Information
.
3.
Expand the
Keys on the Key Server Token
area to see the keys on the key server token.
Changing the key server token password when using the MSL Encryption Kit
Procedure
1.
Navigate to the
Configuration > Encryption > USB—MSL Encryption Kit
screen.
2.
Expand the
Password Management
section.
3.
Enter the current and new key server token passwords.
4.
The key server token password must be at least 8 characters and no longer than 16 characters. The
key server token password must contain at least one lower case letter, one upper case letter, and at
least two digits.
5.
Click
Submit
.
MSL Encryption Kit configuration
77
