2
1
TIP:
If the end of the spooling cable drops into the module, unlock the robotic assembly, remove it
from the module, return the end of the spooling cable to its cradle, return the robotic assembly
to its previous position in the module, relock the robotic assembly, and repeat the procedure.
11.
Unlock the robotic assembly, allow it to move approximately 25mm into the base module and then
lock the robotic assembly.
Completing the robotic assembly and spooling mechanism installation
Procedure
1.
Replace the top cover on the base module if you removed one.
2.
From the front of the rack and while supporting the bottom of the module in areas supported by the
rack shelves, set the back of the base module on the front of the rack shelves. Push the base module
into the rack until the front of the module contacts the front rack posts.
3.
If there are adjacent modules:
a.
Set the alignment mechanisms to the lock position. If you encounter resistance, adjust the upper
module so the pin in the alignment mechanism moves into the hole in the lower module.
b.
Reconnect the expansion interconnect cables.
4.
Using a #2 Phillips screwdriver, tighten the captive fasteners on the front of the base module and its
adjacent modules until they are finger tight. Do not over tighten.
5.
Replace the magazines.
6.
Reconnect the Ethernet, SAS, and Fibre Channel cables to the base module.
7.
Insert any USB devices removed during this procedure.
8.
Reconnect the AC power cables to the base module.
158
Completing the robotic assembly and spooling mechanism installation
