HP storageworks 2/32, Installation Manual

Page: 97 / 138

Using the Embedded Web Server
97 Edge Switch 2/32 Installation Guide
e. Select the Interop mode:
— HP Fabric 1.0 . (default). Select this mode if the fabric contains only
HP switches and switches that are operating in HP Fabric 1.0 mode.
— Open Fabric 1.0 . Select this mode if the fabric contains HP directors
and switches, as well as other open-fabric compliant switches. Select
this mode for managing heterogeneous fabrics.
5. Click Activate to save the information. The message
Your changes to
the operating parameters configuration have been
successfully activated
displays.
6. Set the switch online:
a. At the View panel, select Operations at the left side of the panel. The
Operations panel opens with the Switch Beacon page displayed.
b. At the Operations panel, click the Online State tab, then click Set
Online . The message
Your operations changes have been
successfully activated
displays.
Configure Network Information
Verify the type of LAN installation with the customer’s network administrator. If
one switch is installed on a dedicated LAN, network information (IP address,
subnet mask, and gateway address) does not require change. Go to “
Configure
Switch Ports ” on page 89.
If multiple switches are installed, or a public LAN segment is used, network
information must be changed to conform to the customer’s LAN addressing
scheme. Perform one of the following:
■ If network information was changed while performing “ Configure Switch
Network Information ” on page 38, this procedure is not required. Go to
“ Configure SNMP Trap Message Recipients ” on page 100.
■ If network information was not changed, perform this procedure.
Perform the following steps to change a switch IP address, subnet mask, or
gateway address.
1. Choose Configure at the left side of the window. The Configure window
opens with the Ports page displayed.