HP StorageWorks 1/16 Tape SuperLoader, Manual, Page: 43 / 146

Installation and Configuration
29 1/16 Tape SuperLoader Reference Guide
4. Press Enter.
5. On the Sequential Ops submenu, scroll to Stop Cart.
6. Press Enter.
Ejecting tape from drive
is displayed.
To resume Sequential Mode operation:
1. On the main menu, scroll to Commands.
2. Press Enter.
3. On the Commands submenu, scroll to Sequential Ops.
4. Press Enter.
5. On the Sequential Ops submenu, scroll to Resume.
6. Press Enter.
Ethernet
Ethernet is the method the SuperLoader uses to access a network. With an
Ethernet connection, you can remotely access the SuperLoader over the network
to which it is connected. To use the Ethernet connection, you must define the
following:
■
A dynamic or static IP address for the SuperLoader
■
A subnet mask
■
An IP gateway
■
A Simple Network Management Protocol (SNMP) server
■
A Simple Network Time Protocol (SNTP) time server, or set the time and
timezone manually
SuperLoader IP Address
An Internet Protocol (IP) address is the address of any device that is attached to a
network. Each device must have a unique IP address. IP addresses are written as
four sets of numbers separated by periods ranging from 0.0.0.0 to
255.255.255.255.
IP addresses are either permanent or dynamically assigned. A permanent address
remains the same each time the device connects to a network. A dynamic address
changes each time the device connects to the network, and is assigned by the
network server using a class of software called Dynamic Host Configuration
Protocol (DHCP).