HP ProLiant XL270d Gen9, Maintenance And Service Manual, Page: 54 / 126

13. Install the server into the chassis.
14. Connect all peripheral cables to the server .
15. Power up the server .
Replacing the GPU accelerator power cables
NOTE:
This procedure is not applicable to NVIDIA Tesla P4 GPU.
NVIDIA Tesla P4 GPU does not have any power cables
Procedure
1. Back up all server data.
2. Power down the server .
3. Disconnect all peripheral cables from the server front panel.
4. Remove the server from the chassis .
5. Place the server on a sturdy, level surface.
6. Remove the side panel .
7. Remove all GPUs .
8. Remove all GPU accelerator blanks .
9. To remove the short GPU power cables for slots 3 and 4:
a. Remove the screws to release the retention springs.
Retain the screws for later use.
b. Disconnect the power cables from the power distribution board.
• 8 pin and 6 pin to 8 pin short GPU power cables
54 Replacing the GPU accelerator power cables