HP ProLiant WS460c Gen9, Maintenance And Service Manual, Page: 30 / 102

Removal and replacement procedures 30
6.
Remove the retaining block.
Remove the expansion blade from the host side
1.
Power down the graphics server blade (on page 25 ).
2.
Remove the graphics server blade (" Remove the graphics blade " on page 26 ).
3.
Place the graphics server blade on a flat, level work surface.
4.
Remove the expansion blade access panel (" Expansion blade access panel " on page 31 ).
5.
Remove the foam gasket (on page 27 ).
6.
Disconnect the power cable from the expander power board and the PCI graphics option.
7.
Remove the graphics expansion control cable.
8.
Remove the expansion module from the host server.