HP ProLiant SL4545 G7, Maintenance And Service Manual

Page: 35 / 61

Removal and replacement procedures 35
b.
Tighten the mounting pins to secure the heatsink to the system board.
16.
Install the processor air baffle (on page 28 ).
17.
Install the access panel (on page 23 ).
18.
Install the node into the chassis (" Installing a node into the chassis " on page 22 ).
19.
Power up the server.
SFF backplane board
To remove the component:
1.
Power down the node (on page 21 ).
2.
Remove the node from the chassis (" Remove a node from the chassis " on page 22 ).
3.
Remove the access panel (on page 23 ).
4.
Remove the processor air baffle (" Processor air baffle " on page 28 ).
5.
Disconnect all cables from the SFF backplane board.
6.
Remove two screws securing the board to the node.