Removal and replacement procedures 32
•
Never crease a SATA data cable.
•
Do not rely on components like the drive cage, power supply, or system cover to push cables down
into the chassis.
Removing power supply cables from the system board connectors (J26) follow below steps:
1.
Squeeze on the top of the retaining latch attached to the cable end of the connector.
2.
Grasp the cable end of the connector and pull it straight up.
CAUTION:
Always pull the connector - NEVER pull on the cable. Pulling on the cable could damage
the cable and result in a failed power supply.
Figure 5
Unplugging power cables
Cable connections
The following table provides information about cable connector.
Table 1
Cable connection for SATA LFF HDD (3.5 inch hard disk)
Cable
From
To
SATA cable 1, 2, 3, 4
(two branches each cable)
Power cable
HDD 1,2,3,4
P1, P2, P3, P4 on
personality board
Data cable
HDD 1,2,3,4
J33, J35, J36, J37 on MB
Table 2
Cable connection for SAS LFF HDD (3.5 inch hard disk)
Cable
From
To
Mini-SAS cable
(four branches)
Power cable
HDD 1,2,3,4
P1, P2, P3, P4 on the
personality board
Data cable
HDD 1,2,3,4
J7 on P410 card
Summary of Contents for ProLiant SL335s G7
