HP ProLiant SL170s - G6 Server, Maintenance And Service Manual

Page: 32 / 86

Removal and replacement procedures 32
•
Never bend a SATA data cable tighter than a 30 mm (1.18 in) radius.
•
Never crease a SATA data cable.
•
Do not rely on components like the drive cage, power supply, or system cover to push cables
down into the chassis.
Removing power supply cables from the system board connectors (J36):
1.
Squeeze the top of the retaining latch attached to the cable end of the connector.
2.
Grasp the cable end of the connector and pull it straight up.
CAUTION: Always pull the connector - NEVER pull on the cable. Pulling on the cable could damage
the cable and result in a failed power supply.
Figure 5 Unplugging power cables
Cable connections
The following table provides information about cable connector.
Table 1 SATA cable connections (left/right tray)
System board SATA connector
designator
SATA cable Personality board SATA
connector designator
J32 HDD1 P0
J9 HDD2 P1
J18 HDD3 P2
J19 HDD4 P3
Table 2 Power cable connections
Cable From To
Power convert cable
(
left tray
）
J36 on the system board J2 on the personality board
Power convert cable (right tray) J36 on the system board J2 on the personality board