HP ProLiant ML350 Gen9, Maintenance And Service Manual

Page: 45 / 124

Removal and replacement procedures 45
c.
Finish the installation by completely tightening the screws in the same sequence.
4.
Install the air baffle.
5.
Install the access panel.
6.
Do one of the following:
o
If the server is in a tower configuration, return the server to an upright position.
o
If the server is in a rack configuration, slide the server into the rack.
7.
Connect each power cord to the server.
8.
Connect each power cord to the power source.
9.
Power up the server (" Powering up the server " on page 28 ).
10.
Do one of the following:
o
For tower models, install the tower bezel.
o
For rack models, install the security bezel.
Processor
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent possible server malfunction and damage to the equipment,
multiprocessor configurations must contain processors with the same part number.
CAUTION: The heatsink thermal interface media is not reusable and must be replaced if the
heatsink is removed from the processor after it has been installed.
IMPORTANT: Processor socket 1 must be populated at all times or the server does not
function.
To remove the component:
1.
Do one of the following:
o
For tower models, open and remove the tower bezel (" Remove the tower bezel " on page 28 ).