Removal and replacement procedures 37
c.
Finish the installation by completely tightening the screws in the same sequence.
4.
Install the system air baffle.
5.
If removed, install the PCI air baffle.
6.
Install the access panel.
7.
Return the server to an upright position.
8.
Connect each power cord to the server.
9.
Connect each power cord to the power source.
10.
Power up the server.
11.
Install and lock the tower bezel.
Processor
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION:
To avoid damage to the processor and system board, only authorized personnel
should attempt to replace or install the processor in this server.
CAUTION:
To prevent possible server malfunction and damage to the equipment,
multiprocessor configurations must contain processors with the same part number.
CAUTION:
To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
IMPORTANT:
If installing a processor with a faster speed, update the system ROM before
installing the processor.
To remove the component:
1.
Unlock and remove the tower bezel ("
" on page
2.
Power down the server (on page
3.
Remove all power:
