HP ProLiant EC200a, User Manual

Page: 24 / 73

Hardware options installation 24
4.
Attach the server to the cradle:
a.
Insert the two hooks on the right side of the cradle into the corresponding openings on the bottom
of the server.
b.
Align and insert the two posts on the cradle into the corresponding openings on the bottom of the
server.
c.
Close the latches on the cradle.
Installing the server in the wall mount
Required tools:
•
Stud finder (if installing the wall mount on a hollow wall)
•
Wall marker
•
Level
•
Electric drill
•
Small wire brush (for cleaning the pilot holes)
•
No. 2 Phillips screwdriver
•
Hammer
Process overview:
1.
Determine the location for the wall mount (on page 25 ).
2.
Prepare the server for hardware installation or removal (on page 16 ).
3.
If the server is installed in a cradle or on a storage expansion unit:
o
Remove the server from the cradle (on page 16 ).
o
Remove the server from the storage expansion unit (on page 17 ).
4.
Install the wall mount (on page 25 ).
5.
Install the server in the wall mount (on page 32 ).
6.
Prepare the server for operation (on page 16 ).