HP ProLiant DL60 Gen9, Maintenance And Service Manual, Page: 75 / 113

Removal and replacement procedures 75
Warning: The Product ID should ONLY be modified by qualified service
personnel. This value should always match the Product ID located on the
chassis.
7.
Enter the product ID and press the Enter key.
8.
Press the F10 key to confirm exiting System Utilities. The server automatically reboots.
HPE 550-W Power Supply
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
1.
Power down the server (on page 27 ).
2.
Access the product rear panel (on page 30 ).
3.
Release the power cord from the strain relief clip.
4.
Remove all power:
a.
Disconnect the power cord from the power source.
b.
Disconnect the power cord from the server.
5.
Remove the server from the rack (on page 30 ).
6.
Remove the access panel (" Access panel " on page 37 ).
7.
If installed, remove the primary PCI riser cage. (" Remove the PCI riser cage " on page 32 )
8.
Disconnect all power supply cables from the system board and any associated component (drive
backplane, GPU, etc.).