HP ProLiant DL60 Gen9, Maintenance And Service Manual

Page: 38 / 113

Removal and replacement procedures 38
If the access panel latch is locked, use a T-15 Torx screwdriver to unlock the latch.
To replace the component, reverse the removal procedure.
Four-bay LFF non-hot-plug drive backplane
To remove the component:
1.
Power down the server (on page 27 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page 27 ).
o
Remove the server from the rack (on page 30 ).
4.
Remove the access panel (" Access panel " on page 37 ).
5.
Remove all non-hot-plug drives (" Non-hot-plug drive " on page 35 ).
6.
Disconnect all cables connected to the drive backplane.