PCI-X Technology
12.
Close the PCI-X retaining clip (for full-length expansion boards only).
Figure 7-15: Securing the PCI-X retaining clip
13.
Connect any required cables to the expansion boards.
14.
Replace the rear access panel. Refer to “Replacing the Access Panels” in
Chapter 5, “Installing Hardware Options.”
15.
Restore the server to its operating position in the rack.
16.
Power up the server. Refer to Chapter 9, “Server Setup.”
17.
Be sure that the internal health LED on the front panel LED assembly is
illuminated green, indicating that the system is functioning properly. For detailed
information on LEDs, refer to Appendix E, “System LEDs and Switches.”
If the LED indicates an error, refer to Appendix H, “Troubleshooting,” or refer to the
HP Servers Troubleshooting Guide
for instructions.
HP ProLiant DL580 Generation 2 Server Setup and Installation Guide
7-21
HP CONFIDENTIAL
Writer: Karen Hale File Name: h-ch7 PCI-X Technology.doc
Codename: Wave Part Number: 230835-003 Last Saved On: 6/26/03 9:38 AM
