Memory
Installing a Memory Board
To install a memory board:
1.
Align the memory board with the memory slot and memory board guide clips.
2.
Slide the memory board into the server
(1)
and close the ejector levers
(2)
.
Hot-replacement procedure:
Any LEDs that were amber when the board was
removed from the server now illuminate amber again.
IMPORTANT:
The LEDs relight amber during this step to enable you to verify again
which DIMM failed. If you have already replaced the failed DIMM, disregard the amber
LEDs. The LEDs change back to green after the locking switch is engaged.
3.
Engage the locking switch
(3)
.
Hot-replacement procedure:
All LEDs now turn off except the memory status
LED, which flashes green while data are copied from one memory board to the
other. This process may take up to a minute to complete. When the copying
process is complete, the other LEDs will re-illuminate as described in Table 6-7.
CAUTION:
Do not remove the memory board while the memory status LED is
flashing because the memory board is transferring data. Removing the memory
board during data transfer causes system failure.
Figure 6-7: Installing a memory board
6-24
HP ProLiant DL580 Generation 2 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Karen Hale File Name: g-ch6 Memory.doc
Codename: Wave Part Number: 230835-003 Last Saved On: 6/26/03 9:35 AM
