HP ProLiant DL580 Gen8, Maintenance And Service Manual

Page: 58 / 94

Removal and replacement procedures 58
10.
Power up the server.
I/O board
When replacing the I/O board, be sure the system maintenance switch settings on the replacement board
match the settings on the old board. For more information, see "System maintenance switch (on page 78 )."
To remove the component:
1.
Power down the server (on page 25 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Extend or remove the server from the rack (" Extend the server from the rack " on page 25 , " Remove the
server from the rack " on page 26 ).
4.
Remove the access panel (on page 29 ).
5.
Extend the processor memory drawer approximately 2.54-5.1 cm (1-2 inches).
6.
Remove the SPI board (on page 31 ).
7.
Remove the FlexibleLOM (" FlexibleLOM " on page 63 ).
8.
Remove any expansion boards installed on the I/O board (" Expansion board " on page 40 ).
9.
Disconnect all cables connected to the I/O board.