Operations 27
5.
Release the full-length expansion board retainer, and then remove the PCI riser cage.
6.
Remove the full-length expansion board.
To replace the component, reverse the removal procedure.
Install the PCI riser cage
WARNING:
To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
1.
Power down the server (on page
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Extend the server from the rack (on page
4.
Summary of Contents for ProLiant DL388p
